Description
You may need Spares for your Soloc Freedom belt due to damage or soiling.
FlexiFix Padding Stud Side
You can remove the old padding either by wriggling the padding over the stud or by removing the belt from the chair and sliding the padding up the belt. The latter is easier to do but please ensure that the belt is refitted correctly by a qualified wheelchair fitter.
FlexiFix Padding Buckle Sides
It is harder to remove the padding over the buckle on this side due to the width of the buckle. You may need to remove this side of the belt from the chair. Un-Velcro the buckle from the padding and slide the the padding down the FlexiFix arm. Slide the new padding onto the FlexiFix arm and replace the belt. Please ensure that the belt is refitted correctly by a qualified wheelchair fitter.
Frame Saver Clamps
Frame saver clamps attach the belt to your wheelchair. If they become damaged then please replace them. The Frame Saver Clamps are sold in pairs.
Velcro Adhesive Circle
The Velcro circle adheres to the back of the buckle and holds the buckle in place on the padding. If your Velcro loses its stick due to repeated repositioning of the buckle, then you can buy a replacement here. Peel off the old Velcro circle and stick the new one in its place.
Extender Plate for the FlexiFix Arm
This Extender Plate increases the length of the Soloc FlexiFix arm by 120mm. Use this to increase the length of either side of your Soloc Freedom. You will need to connect the Extender plate to the FlexiFix arm using two of the holes. The instructions included with your Soloc belt show you how to connect the extender plates.
